#WIRING ON OFF SWITCH HOW TO#

I am going off of memory (dont have the boat with me to look at it. This means you had constant going to 2,4,6.the #5 terminal was left empty, '0'=nothingthe '^' is the UP remote/trigger wirethe 'v' is the DOWN remote/trigger wire.IF I REMEMBER correctly, this is how it was. The jumper wires connected to #4 and #6 as well. The three '+' were all connected/jumped together, with the constant power wire coming off of the engine and connecting with the #2 terminal. The number of configurations of available switches is enormous. Use a pair of wire strippers to expose at least 1/2-inch of wire. Make sure there is enough wire exposed to make a connection with the terminal. Notice that these outlets have the tab removed from the 'hot' side or Brass side of the outlet which allows the top. The diagram below shows the power entering the circuit at the grounded outlet box location, then sending power up to the switch and a switched leg back down to the outlet. Use a pair of needle-nose pliers to clamp the ends of the wire around the screw. These electrical wiring diagrams show typical connections. I only had 3 wires, 2 remotes (up and down), and a constant power.OK, the '+' symbol will equal the 'COMMON', or constant power source. To turn a light on or off only takes the SPST, the most common switch that has just 2 terminals. Make sure they are hooked tightly around the screw before tightening them back down. The jumper wires connected to 4 and 6 as well. The three '+' were all connected/jumped together, with the constant power wire coming off of the engine and connecting with the 2 terminal.

Let me see if I can simulate how I wired it up using a keyboard.This was a '6' terminal momentary on/off/momentary on switch. I only had 3 wires, 2 remotes (up and down), and a constant power.

OK, the '+' symbol will equal the 'COMMON', or constant power source.

This is the simplest arrangement for more than one light on a. The hot and neutral terminals on each fixture are spliced with a pigtail to the circuit wires which then continue on to the next light. The source is at SW1 and 2-wire cable runs from there to the fixtures.

#WIRING ON OFF SWITCH HOW TO#

Re: How to wire a momentary on/off/momentary on Toggle switch? This diagram illustrates wiring for one switch to control 2 or more lights.

Wiring on off switch